Gecko [ lorencats.com ]

Name	Size	Permission
EnableSeq.conf	649 B	-rw-r--r--
HeadPhones.conf	376 B	-rw-r--r--
IN1-HeadsetMic.conf	439 B	-rw-r--r--
IN1-InternalMic.conf	409 B	-rw-r--r--
IN2-HeadsetMic.conf	439 B	-rw-r--r--
IN2-InternalMic.conf	409 B	-rw-r--r--
MonoSpeaker.conf	1.14 KB	-rw-r--r--
Speaker.conf	304 B	-rw-r--r--

Code Editor : MonoSpeaker.conf

SectionDevice."MonoSpeaker" {
	Comment "Mono Speaker"

ConflictingDevice [
		"Speaker"
		"Headphones"
	]

EnableSequence [
		cdev "hw:bytchtes8316"

# BYT/CHT devices with an ES8316 codec use a single speaker
		# connected between the headhpone LOUT and ROUT pins, expecting
		# the output to be in a mono differential mode. Presumably this
		# is done to use the power of both the left and right headphone
		# amplifier channels to allow the speaker to be louder.
		#
		# The ES8316 codec does not have a differential output mode, but
		# we can emulate one by making both channels output the exact
		# same signal by setting the "DAC Mono Mix Switch", combined
		# with setting the "Playback Polarity" control to "R Invert",
		# which applies a 180 degrees phase inversion to the right chan.
		cset "name='DAC Mono Mix Switch' on"
		cset "name='Playback Polarity' 1"

cset "name='Speaker Switch' on"
	]

DisableSequence [
		cdev "hw:bytchtes8316"
		cset "name='Speaker Switch' off"
		# DAC settings back to normal for stereo headphones output
		cset "name='Playback Polarity' 0"
		cset "name='DAC Mono Mix Switch' off"
	]

Value {
		PlaybackChannels "2"
	}
}

${this.title}

Code Editor : MonoSpeaker.conf